next up previous contents index
Next: 3D-Visualization of Neural Up: Pruning Algorithms Previous: Non-contributing Units

Pruning Nets in SNNS


To use one of the pruning algorithms mentioned above, set the learning function in the control panel (options menu, see section gif) to PruningFeedForward.

Note: This information is saved with the net. Be sure to check the learning function each time you reload the net.

The pruning algorithms can be customized by changing the parameters in the pruning panel (see figure gif) which can be invoked by choosing PRUNING in the main menu. The figure shows the default values of the parameters.

Figure: Pruning Panel

The first block of the panel controls the pruning, the second the embedded learning epochs and the last two specify parameters for certain pruning algorithms. To save the changes to the parameters and close the pruning panel, press the button .

The current pruning function is shown in the box `` General Parameters for Pruning''. To select a different one, press the button which pops up a list of the available pruning functions, analogous to the change of the learning function.

There are two criterions to stop the pruning: The error after retraining must not exceed

Normally, the state of the net before the last (obviously too expensive) pruning is restored at the end. You can prevent this by switching the radio buttons next to `` Recreate last pruned element'' to .

The second box in the pruning panel (`` General Parameters for Learning'') allows to select the (subordinate) learning function in the same way as the pruning function. Only learning functions for feed-forward-nets appear in the list. You can select the number of epochs for the first training and each retraining separately. The training, however, stops when the absolute error falls short of the `` Minimum error to stop''. This prevents the net from overtraining.

The parameter for OBS in the third box is the initial value of the diagonal elements in the Hesse-Matrix. For the exact meaning of that parameter (to which OBS is said to be not very sensible) see [BH93].

The last box allows the user to choose which kind of neurons should be pruned by the node pruning methods. Input or hidden unit pruning can be selected by two sets of radio buttons.

Learning Parameters of the subordinate learning function have to be typed in in the control panel, as if the training would be processed by this function only. The field in the control panel has no effect on pruning algorithms. To start pruning, press the button in the pruning panel and the button or respectively in the control panel.

next up previous contents index
Next: 3D-Visualization of Neural Up: Pruning Algorithms Previous: Non-contributing Units
Tue Nov 28 10:30:44 MET 1995